○○○○○○○○○○○○○○○○○○○○○○
Recording a Song 6•9
RECORDING
1. Press PLAY to start the recording. If Count-
down is ON wait for the countdown to finish
before playing (events are not recorded dur-
ing the countdown phase).
2. Start to play after the countdown. Events will
be recorded in the track or tracks active for
recording.
3. When you have finished, stop the recording
with STOP.
○○○○○○○○○○○○○○○○○○○○
©
Note: Pressing STOP twice rewinds the Song
○○○○○○○○○○○○○○○○○○○○
back to the beginning.
4. To add additional events to the same tracks,
press STOP again to take the song pointer
to the starting point and repeat points 1 - 3.
○○○○○○○○○○○○○○○○○○○○
©
Note: To add notes to existing ones in a track,
select the Overdub option. To substitute existing
notes in a recorded track with new ones, select the
○○○○○○○○○○○○○○○○○○○○
Replace option.
5. If you are satisfied with the recording, con-
firm the track or tracks by pressing the corre-
sponding Soft buttons. The recording will be
confirmed and the tracks set to «seq-play».
6. Repeat the recording procedures for other
tracks.
7. Press RECORD to escape «Record» mode.
The LED of the RECORD button goes off and
the display returns to normal.
UNDO
If, during the recording phase, you want to can-
cel the last performed recording task, use UNDO
to cancel the last performed task. The UNDO
button is located to the right of the display, just
after the Contrast knob.
For example, after adding new events to an ex-
isting drum pattern, you might want to return to
the original pattern and just cancel the new
events. A quick an easy way is to use UNDO.
Just press UNDO and confirm the request with
ENTER or cancel with ESCAPE.
1. If, after recording a track, you wish to return
to the previous situation, press UNDO.
UNDO
You are prompted with a request to confirm
the operation.
2. Press ENTER to cancel the last performed
operation, or ESCAPE to cancel the request
and retain the last operation.
To Next Page
Loading...
Need help?
General
