Cinterion
®
Java Terminal Hardware Interface Description
8.3 Complete Watchdog Configuration
90
PLS62T-W_HID_v01 2018-06-20
Confidential / Prelimenary
Page 71 of 91
8.3.1.7 Restart Delay
This command configures the MIN_START_TIME timeout value. By setting the MIN_START_-
TIME, the watchdog no longer performs a module reset for the given amount of time, after mod-
ule startup. Whenever the module has been reset and restarted, as well as after the watchdog
has been enabled, the watchdog will wait for MIN_START_TIME before performing any (fur-
ther) resets. The watchdog‘s reset timer only starts after the MIN_START_TIME has expired.
Changing this configuration disables the watchdog. The feature becomes active, if the watch-
dog is enabled again.
It is strongly recommended to set this value to a time period of more than 30 minutes for normal
operation. During development it may be set to values of less than 30 minutes, but should al-
ways be greater than the time the module needs for a complete start up including Java. Also,
a Java module firmware or userware update right after startup should be taken into account
which may take up to 15 min.
Command MIN_START_TIME
Parameter <timeout>
Type Milliseconds
Range 0 .. 2
32
-1
Default 18000000ms (30 minutes)
Non-volatile Yes
Example WD=MIN_START_TIME,18000000,9 // Prevents module resets for 30 minutes after
each module startup, and after the watchdog
becomes active
To Next Page
Loading...
Need help?
General