Cinterion
®
Java Terminals Hardware Interface Description
8.3 Configuration via ASC0 Interface
69
EHSxT_BGS5T_HID_v02 2014-05-23
Confidential / Preliminary
Page 61 of 70
8.3.1.7 Always On
This command configures the on/off-state observation of the module by specifying a timeout
value for ALWAYS_ON. If enabled, the watchdog observes the module‘s internal V180 signal.
If the watchdog detects that the module is OFF, it will restart the module after the timeout of
ALWAYS_ON milliseconds.
Changing this configuration disables the watchdog. The feature becomes active, If the watch-
dog is enabled.
It is strongly recommended to set this value to a time period of more than 1 minute for normal
operation to avoid oscillation in e.g. out-of-temperature events. In case of over/under temper-
ature shut down it can be expected that the temperature does not change significantly within a
minute. During development the timeout may be set to a period of less than 1 minute.
8.3.1.8 Load Default Values
This command loads the default configuration values. This disables the watchdog. If the watch-
dog is enabled, the reset timeout values, the MIN_START_TIME timeout and the
ALWAYS_ON timeout become active. Other configuration values become active immediately.
The loaded default values are also persistent, i.e. written to the flash memory.
Command ALWAYS_ON
Parameter <timeout>
Type Milliseconds
Range 0 .. 2
32
-1
Default 0: Feature is disabled
Non-volatile Yes
Example WD= ALWAYS_ON,60000,6 // Observes the module and restarts it 60 seconds
after it has been turned off
Command DFT_VAL
Parameter <1>
Type Fixed
Range 1
Default ---
Non-volatile No
Example WD= DFT_VAL,1,1 // Loads the default values
To Next Page
Loading...
Need help?
General
