UK
1.0
2.0
3.0
4.0
5.0
6.0
- INTRODUCTORY NOTE
- ALARM SYSTEM CONTROL DEVICES
- SYSTEM OPERATION - BASIC CONFIGURATION
3.1 - Arming
3.2 - Top case/seat open warning
3.3 - Arming delay
3.4 - Siren exclusion
3.5 - ensor exclusion
3.6 - Full arming
3.7 -
3.8 - Limitation of audible alarms
3.9 - Neutral time between alarm events
3.10 - System disarming without alarm memory
3.11 - System disarming with alarm memory
- PROGRAMMABLE FEATURES
4.1 - Optical/acoustic signals
4.2 - Panic alarm via remote control
4.3 -
4.4 - Passive arming
4.5 - Anti-hijack feature
4.6 - Pre-alarm
4.7 - Self-rearming
-
-
PIN CODE OVERRIDE
PIN CODE OVERRIDE EXAMPLE
PIN CODE CUSTOMIZATION
USER MANUAL
Tilt s
Alarm events
Tilt sensor
SLEEP MODE - ENERGY SAVER FEATURE
HAZARD WARNING FLASHERS
-
-
-
- REPLACING REMOTE CONTROL BATTERIES
- TECHNICAL SPECIFICATIONS
-
- USE AND MAINTENANCE
- WARRANTY CONDITIONS
7.0
8.0
9.0
10.0
11.0
12.0
13.0
14.0
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
DIRECTIVE
CONTENTS
CONTENTS
INSTALLER MANUAL
FITTING INSTRUCTIONS
23.1 - With Brown/Green wire grounded
23.2 - Without grounding the Brown/Green wire
15.0
16.0
17.0
18.0
19.0
20.0
21.0
22.0
23.0
24.0
25.0
26.0
-
- ALARM UNIT SEALING
- ALARM UNIT POSITIONING
- ACCESSORIES - FITTING
18.1 - Status LED
18.2 - Contact switch (optional)
18.3 - Anti-hijack button (optional)
- PINOUT TABLE
- WIRING DIAGRAM
- IMMOBILIZER CONNECTIONS
- DIODE INSTALLATION
- LEARNING NEW DEVICES
- PROGRAMMABLE FEATURES
- PROGRAMMING EXAMPLE
- TILT SENSOR ADJUSTMENT
PAGE 1 PAGE 2
To Next Page
Loading...
