ATTENTION
!
CAUTION
Non compliance to this instruction could result in serious damage to the
vehicle and to the alarm system.
Non compliance to this instruction may cause damage or operational
failures to the alarm system.
USER MANUAL
1.0 - INTRODUCTORY NOTE
Dear customer,
This alarm system, designed and manufactured in Italy specifically for 2-
wheeled vehicles, is supplied with 2 remote controls. It is not powered by a
backup battery.
The alarm is factory programmed but the features can be user-customized and
the tilt/shock sensor sensitivity adjusted (see par. 26.0).
Please read the present manual carefully to familiarize yourself fully with the
alarm features and operating procedures and do keep it handy for future
reference.
2.0 - ALARM SYSTEM CONTROL DEVICES
The remote controls are used to operate the alarm system. A PIN code can be
entered to emergency override the system should the remotes be lost or
inoperative.
Override PIN code is entered by means of the vehicle ignition key (see chapter 8.0).
Button 1
LED
indicator
Button 2
The following signal words are included in the present manual to emphasize
important instructions and to alert the user/installer to potential hazards:
PAGE 3 PAGE 4
The remote control has a low charge battery indicator that gives early warning
to avoid malfunctioning. When the batteries are low, the LED will blink when a
button is pressed. Replace the batteries: weak batteries will prevent the
remote control from properly operating the alarm system.
The remote control has 2 buttons that activate several functions based on the
alarm configuration:
Button 1
(textured):
Button 2
(smooth):
• Alarm system arming/disarming.
• Anti-hijack activation.
• Hazard flashers activation.
• Anti-hijack activation.
• Panic alarm activation/deactivation.
• Siren silencing during an alarm.
• Siren exclusion when arming.
• Tilt sensor exclusion.
The 952N alarm system cannot be paired with transponder
TAG 908.
To Next Page
Loading...
Need help?
General
