Gemini GEM-P9600 Programming Instructions

L
NAPCO Security Systems
X
GEM-P9600 Programming Instructions
WI777D 08/00
!
Page 65
USER PROGRAM MODE
PRELIMINARY INFORMATION
The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up or while any area is armed.
!
After entering codes or data, press the save
J
button. Data will not be stored into memory unless this button is pressed.
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound. Press the
C button to silence the sounder and exit the User Program Mode.
If a GEM-RP2ASe2 is used, configure address jumpers as Keypad #1 (see the section of this manual Configuring the GEM-RP2ASe2
Keypad). Use the A button to manually scroll the display at the end of each programming line.
NOTE:
For ease of programming, it is recommended that a GEM-RP1CAe2 be used as Keypad #1. (A new GEM-RP1CAe2 is
automatically configured as Keypad #1.)
ACCESSING USER PROGRAM MODE
1. Press
EEEEEE A
2. Press
g
Until
“
ACTIVATE PROGRAM Y/N
”
(GEM-RP1CAe2) or
“
TURNON PROG Y/N
” (GEM-RP2ASe2)
appears on LCD screen.
3. Press
F
To Enter User Program Mode
4. Press
C
To Exit User Program Mode when finished
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
USER CODES
Up to 96 User Codes may be programmed.
NOTE:
In this mode, only the code is
programmable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 9).
!
Use the A button to place the cursor
over the User Number.
!
Enter a User Number (01–96) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
GEM-RP1CAe2 Keypad (Direct Entry)
ENTER USER CODE
U01 123___ -_ _ -__
Programming User Codes
User Code NOT USED
To Program User Codes
1. Set Cursor Position using
the
A
button.
2. Enter 2-digit User Number
(01-96) directly using
number buttons (0-9).
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
J
button to save
each code.
NOTE:
Press
G 0
button to clear character at cursor.
To continue press
E
or
F
button.
R
COMPUTERIZED SECURITY SYSTEM
GEMINI
ARMED
STATUS
SYSTEM ARMED
01/01/97 12:00AM
12
4
3
56
7890
A
B
C
D
E
F
G
NEXT/YES
PRIOR/NO
AREA
# OF ZONES IN AREA 1
ENTER # ZONES X X
ENTER USER CODE

U01 123___ - _1 - __
User Program Mode: Accessing Program Mode

Gemini GEM-P9600 Specifications

General

Brand	Gemini
Model	GEM-P9600
Category	Security System
Language	English