Gemsy 500 - 3.2 Monitoring Mode; 3.3 Safety Switch Warning Mode

上海鲍麦克斯电子科技有限公司 AS系列数控交流伺服系统说明书
10
234 0／1 0
Motor direction:
0: CW
1: CCW
240 0～9999 1000
The ratio between motor and machine (1000 stands for 1:1)
242 0～359 0
Up needle stop angle (After detecting the synchronizer signal)
243 0～359 175
Down needle stop angle
244 0~800 200
Running delay time when presser footer comes down (ms)
247 0～2000 0
The alarm time for adding oil (hours), disabled when setting 0
248
0～4000
0
Gas alarm, prohibit running time (hour) 0: close this feature
3.2 Monitoring Mode
No. Description No. Description
010 Counter for stitches 026 The ratio between motor and machine
011 Counter for sewing pieces 027 The total used time(hours) of motor
013 State of encoder 028 The sampling voltage of interaction
020 DC voltage 029 Software version
021 Machine speed 02A analog input 1 sample value
022 The phase current
02B
analog input 2 sample value
023 Initial electrical angle
02C
Error Counter
024 Machine angle
02D
QP Ultra-state
025 The sampling voltage of pedal 030-037
The history record of error codes
3.3 Safety switch warning mode
Alarm code Description Corrective
Fuel filling warning Fuel filling. Press P key to clear.
Count over for
stitches
The counter reaches the limit. Press P key to reset the
counter.
Count over for
sewing pieces
The counter reaches the limit. Press P key to reset the
counter.
Emergency stop Press the key of emergency stop to clear.
Lift needle locking
Then press the needle lifting locking button, can eliminate
the needle lifting locking state
Power is off Please wait for 30 seconds, then turn on the power switch
Safety switch alarm Adjust the machine to the correct position.