20
Step 2 Connect the display to the power supply. Switch on the rocker switch
(on the right bottom of the rear of the display, next to the power port) to
enter the standby status. The power indicator turns red.
For 65”/70”
Rocker switch
(next to the power port)
For 75”/80”/86”
Rocker switch
( nex t to the power port)
Step 3 Press power switch on the control panel or Power on the remote
controller to turn on the interactive display. The OPS is booted up and
the power indicator turns green.
Power switch
(on the front panel)
3 BASIC OPERATION
To Next Page
Loading...