Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
40
RESET PORT
Path: / CONFIGS COMM-PARAM PORT-1 RESET-PORT
Type: Executable
Syntax: RESET-PORT
Notes: RESET-PORT resets the given port. The electrical interface is initialized and the
shell (if any) that was running on it is restarted.
RESET PORT
Path: / CONFIGS COMM-PARAM PORT-2 RESET-PORT
Type: Executable
Syntax: RESET-PORT
Notes: RESET-PORT resets the given port. The electrical interface is initialized and the
shell (if any) that was running on it is restarted.
RESET PORT
Path: / CONFIGS COMM-PARAM PORT-3 RESET-PORT
Type: Executable
Syntax: RESET-PORT
Notes: RESET-PORT resets the given port. The electrical interface is initialized and the
shell (if any) that was running on it is restarted.
RESTORE BEACONS
Path: / CONFIGS BEACONS RESTORE-BEACONS
Type: Sub Menu
Syntax: RESTORE-BEACONS
Notes: Executing each item in this menu will RESTORE values previously stored as a
BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER, SLOPE, VOLT
RANGE, MIN REF LVL, and ATTENUATION.
To Next Page
Loading...