Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
42
RESTORE ROM DEFAULTS
Path: / CONFIGS MEMORY RESTORE-TO-ROM-DEFAULTS
Type: Data Editor
Syntax: RESTORE-TO-ROM-DEFAULTS [= n] | [D]
Range: Integer: 0 .. 1
0 No
1 Yes
Notes: Selecting YES and pressing ENTER restores all DTR parameters to factory ROM
defaults. If this is done, the front panel (not the whole DTR) will reset.
SAMPLING FREQUENCY
Path: / CONFIGS MEMORY CALIBRATION SAMPLING
Type: Data Editor
Syntax: SAMPLING [= n] | [D]
Range: Real: 63990.000 .. 64010.000
Notes: SAMPLING FREQUENCY compensates for the oscillator’s slight deviation from
64MHz. Entering the actual oscillator frequency to within 1Hz maximizes the
receiver’s performance.
SET DATE AND TIME
Path: / CONFIGS MEMORY DATE&TIME
Type: Sub Menu
Syntax: DATE&TIME
Notes: The SET DATE and TIME menu contains editors for setting the date and time. The
port used to set the date or time with (local or remote) must be the one in control.
SET DATE
Path: / CONFIGS MEMORY DATE&TIME SET-DATE
Type: Data Editor
Syntax: SET-DATE [= n] | [D]
Range: Integer: 1011980 .. 12312079 (Must be a valid date)
Notes: Changing this changes the current date. Under the menu tree shell the format is
MMDDYYYY and all fields must be set.
To Next Page
Loading...