Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
14
ATTENUATION
Path: / CONFIGS OPERATION ANALOG-OUTPUTS ATTENUATION
Type: Data Editor
Syntax: ATTENUATION [= n] | [D]
Range: Real: 0.0 .. 50.0
Notes: ATTENUATION controls the lower end of the DAC voltage output, in conjunction
with the parameters in the ANALOG OUTPUTS configuration menu.
V1.19.13 or earlier this parameter was in the MAIN MENU with path
/ ATTENUATION. It was replaced by INPUT ATTEN and moved to sub-menu
ANALOG OUTPUTS in v1.19.15.
BAND 1 (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-1
Type: Sub Menu
Syntax: BAND-1
Notes: The conversion parameters of the Block Downconverter to support this BAND must
be defined here to provide conversion to L-Band frequency.
BAND 2 (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-2
Type: Sub Menu
Syntax: BAND-2
Notes: The conversion parameters of the Block Downconverter to support this BAND must
be defined here to provide conversion to L-Band frequency.
BAND 3 (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-3
Type: Sub Menu
Syntax: BAND-3
Notes: The conversion parameters of the Block Downconverter to support this BAND must
be defined here to provide conversion to L-Band frequency.
To Next Page
Loading...