Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
15
BAND 4 (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-4
Type: Sub Menu
Syntax: BAND-4
Notes: The conversion parameters of the Block Downconverter to support this BAND must
be defined here to provide conversion to L-Band frequency.
BDC GAIN (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-1 BDC-GAIN
Type: Data Editor
Syntax: BDC-GAIN [= n] | [D]
Range: Real: 0.0 .. 31.0
Notes: The GAIN in dB, of the BDC and attenuator pair that supports this band. The typical
range for this parameter is 2-4 dB when using BDCs and 10 dB pads as provided by
GDST. NOTE: This parameter is set in the factory and should not be changed under
normal circumstances.
BDC GAIN (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-2 BDC-GAIN
Type: Data Editor
Syntax: BDC-GAIN [= n] | [D]
Range: Real: 0.0 .. 31.0
Notes: The GAIN in dB, of the BDC and attenuator pair that supports this band. The typical
range for this parameter is 2-4 dB when using BDCs and 10 dB pads as provided by
GDST. NOTE: This parameter is set in the factory and should not be changed under
normal circumstances.
To Next Page
Loading...