General Dynamics DIGITAL TRACKING RECEIVER - Page 77

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
16
BDC GAIN (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-3 BDC-GAIN
Type: Data Editor
Syntax: BDC-GAIN [= n] | [D]
Range: Real: 0.0 .. 31.0
Notes: The GAIN in dB, of the BDC and attenuator pair that supports this band. The typical
range for this parameter is 2-4 dB when using BDCs and 10 dB pads as provided by
GDST. NOTE: This parameter is set in the factory and should not be changed under
normal circumstances.
BDC GAIN (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-4 BDC-GAIN
Type: Data Editor
Syntax: BDC-GAIN [= n] | [D]
Range: Real: 0.0 .. 31.0
Notes: The GAIN in dB, of the BDC and attenuator pair that supports this band. The typical
range for this parameter is 2-4 dB when using BDCs and 10 dB pads as provided by
GDST. NOTE: This parameter is set in the factory and should not be changed under
normal circumstances.
BEACON SETUP
Path: / CONFIGS BEACONS
Type: Sub Menu
Syntax: BEACONS
Notes: A subset of DTR system parameters may be stored as BEACONS to provide parallel
control via I/O INTERFACE #1. This provides support of legacy GDST interfaces
such as the 7134ACU.