Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
26
HARDWARE OPTIONS (v1.19.08 or later)
Path: / CONFIGS MEMORY CALIBRATION OPTIONS
Type: Sub Menu
Syntax: OPTIONS
Notes: Contains settings for special hardware configurations. These settings are typically
made in the factory and should not be changed under normal circumstances.
CHANGING THE PARAMETERS IN THIS MENU MAY DEGRADE THE PERFORMANCE
OF THE DTR.
HIGH FREQ (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-1 HIGH-FREQ
Type: Data Editor
Syntax: HIGH-FREQ [= n] | [D]
Range: Real: 945.000 .. 13000.000 (v2.0.7 or later)
Real: 949.000 .. 13000.000 (v2.0.4 or earlier)
Notes: HIGH end FREQUENCY of the BDC that supports this band. Typical configurations:
S-band = 2800MHz
C-band = 4200MHz
X-band = 7750MHz
Ku-lo-band = 11700MHz
Ku-hi-band = 12750MHz
Ka-A = 18100, Ka-B = 19200, Ka-C = 20200, Ka-D = 21200, Ka-E = 22300
HIGH FREQ (OPTIONAL-Depending on RF Range)
Path: / CONFIGS BANDS BAND-2 HIGH-FREQ
Type: Data Editor
Syntax: HIGH-FREQ [= n] | [D]
Range: Real: 945.000 .. 13000.000 (v2.0.7 or later)
Real: 949.000 .. 13000.000 (v2.0.4 or earlier)
Notes: HIGH end FREQUENCY of the BDC that supports this band. Typical configurations:
S-band = 2800MHz
C-band = 4200MHz
X-band = 7750MHz
Ku-lo-band = 11700MHz
Ku-hi-band = 12750MHz
Ka-A = 18100, Ka-B = 19200, Ka-C = 20200, Ka-D = 21200, Ka-E = 22300
To Next Page
Loading...