8
1. Turn the knob clockwise to unlock the upper wheel
door, then open the door.
ASSEMBLY INSTRUCTIONS
Serious personal injury could occur if you connect the machine to the power source before you have completed
the installation and assembly steps. DO NOT connect the machine to the power source until instructed to do so.
For your convenience this bandsaw is shipped from the factory partially assembled and requires only minimal
assembly and set up before being put into service.
2. Remove the nut from the provided hoisting eye-
bolt and insert the eyebolt in the hole located on
top of the bandsaw.
INSTALLING THE HOISTING EYEBOLT
3.
Put the nut back and tighten firmly, using the supplied 19 mm wrench, then close and lock the upper wheel door.
PREPARING TABLE INSTALLATION
1
. Remove the table tilt trunnion bolt and flat wash-
er , located on the trunnion support bracket
and set it aside.
2. Remove the table aligning pin from the table
slot on the front of the table.
Note: The table aligning pin should be easily remova-
ble with fingers only. If it is jammed, use pliers to remo-
ve it from the table slot.
To Next Page
Loading...
