General Excalibur 40-200C

Carefully unpack and remove the components of the following 5 boxes - that make up a complete Excalibur Router
Table - and check for damaged or missing items as per the list of contents below.
NOTE: Please report any damaged or missing items to your General International distributor immediately.
UNPACKING (CNT’D)
40-075 CAST-IRON TABLE (40-200C) *
LIST OF CONTENTS QTY
a- 24” X 32” CAST-IRON TABLE........................... 1*
b-
HEX NUT ........................................................ 10*
c-
LEVELER SCREW ............................................ 10*
d-
FLAT WASHER .................................................. 6*
e-
LOCK WASHER ............................................... 6*
f-
HEX SOCKET CAP SCREW .............................. 6*
Note: Supplied hardware is the same for 40-200C or
40-200P with cast-iron or phenolic table.
For 40-200M with MDF table, the following hardware
is supplied:
a- WOOD SCREW ............................................... 10
b-
WOOD NUT ....................................................... 2
c-
SELF TAPPING SCREW .................................... 32
* Model #40-075 for 40-200C Cast-iron
table shown.
*
a
b
c
d
e
f
10
mounting hardware for #40-075 cast-iron
and #40-045 phenolic table
ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person for help with lifting
(cast-iron table)
• Straight edge
•
Phillips screwdriver
• Socket wrench set
• Wrench set
• Allen key set
*
a
c
mounting hardware for #40-049
MDF table
b