Genesis Electrified GV70 - Page 524

7-114
Driver assistance system
Information
• Driving Speed Limit helps you drive
below 60 km/h (40 mph). At this time,
the vehicle decelerates due to the
vehicle ahead. After the vehicle has
decelerated, it cannot automatically
accelerate.
• Driving Speed Limit will cancel in the
following circumstances:
- When the driver grabs the steering
wheel again
- When the driver turns on Lane
Following Assist by pressing the Lane
Driving Assist button
- When +, -, switch or button is
operated, or the accelerator pedal or
the brake pedal is depressed
Highway Lane Change Assist (if
equipped)
Displaying operating status
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to “View Modes” section in chapter
4.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
OJKEV072250LOJKEV072250L
[A]: Ready/Operating, [B]: Standby/Cancelled
(1) Highway Lane Change Assist
indicator
• Green on : Ready state
• Green blink : Operating state
• Grey on : Standby state
• White blink : Canceled state
(display only a certain time)
(2) Lane line
The lane line is displayed same as
the Highway Lane Change Assist
indicator (1). However, if the function
is on standby, it displays whether the
lane line is detected.
(3) Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4) Message
• Message is displayed when the
function does not operate even
though the turn signal is used.
• Message is displayed when
the function is cancelled while
operating.