Refrigerated High-Speed Micro Centrifuge, 1730R
13
4.3 Setting Time
Time can be set at ‘Minute’ and ‘Second’ and the operation time is available up to 99
min 59 sec or continuous (00 min 00 sec).
Two alternative time counter modes are available. When‘AT SET SPEED’ mode is not set,
the time countstarts at the point whenSTART/STOP [ ] button is pressed. On the other hand,
the ‘AT SET SPEED’ mode counts the time of rotation at the set speed.
4.3.1 Setting AT SET SPEED
Action
4.3.2 Setting Time
Time setting unit: 1min. / 1 sec.
Action
Touch [AT SET SPEED] button once.
AT SET SPEED Mode:
For exact time control, this instrument can be set with AT SET
SPEED mode which counts the run time once the actual run speed
reaches to the set speed value and stops when the deceleration
begins.
Touch[TIME] button once.
If [TIME] button is touched once, the input value of the
‘SEC’signflickers.
Touch Up [ ] or Down [ ] bu
tton to change the second
value.
If you do not touch the Up/Down button for 15 seconds, the
setting mode is cleared.
Touch [ENTER] button to pass the ‘MIN’ value setting.
1
1
2
*[AT SET SPEED] lamp turns on: From t1 to t2
*[AT SET SPEED] lamp turns off: From t0 to t2
To Next Page
Loading...