A Monthly:
• Door springs and door hardware:
– Oil door roller, bearings, and hinges using silicone
lubricant or light oil.
• Balance Door.
–Close door.
–
Release Magnetic Carriage Assembly from Rail Assembly
by pulling down on Emergency Release Knob.
–Raise door manually 3'- 4' and verify that door stays at
that position. See Check Step 2 on page 3.
–Reattach Magnetic Carriage Assembly to Rail Assembly:
a.
Pull the Emergency Release Knob toward Power Head.
b. Close door.
•Contact Reverse Test.
–Perform Installation Step 10 on page 21.
B Yearly:
• Wipe off old excess lubricant from Drive Screw.
• Lubricate Drive Screw with Genie Lubricant (GLU-3)
25
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
I
NSTALL LIGHT BULBS
AND
LENS
Installation Step 13:
A Install two 60 Watt light bulbs (not included) into Light
Sockets (Figure 41):
• Rough service, 130 Volt bulbs are recommended.
B Install Lens into slots in Motor Cover.
C Install Genie Emergency Release Kit (GER-2) accessory,
if purchased.
D Installation is now complete.
NOTE
When the door is 3' - 4' above the ground, the door
should stay open. Slight movement is acceptable. If
the door moves too much, contact a Genie Factory
Authorized Dealer for service or call Customer Service at
1-800-35-GENIE.
WARNING
Do not operate door automatically or manually if springs
are broken. Contact a Genie Factory Authorized Dealer for
service or call Customer Service at 1-800-35-GENIE.
Snap Lens Hinges into
slots on back of Motor Cover
60 Watts
maximum
Push in
Latches
to
close Lens
Figure 41 Install Lens Cover and Light Bulbs
Transmitter Compliance Statement
MAINTENANCE
WARNING
If the door fails to reverse on contact with the board,
adjust the Close Force Control as specified in Set Limit
Switches and Force Controls on page 20. If the Opener
still fails, contact a Genie Factory Authorized Dealer for
service or call Customer Service at 1-800-35-GENIE.
NOTE
Use ONLY Genie Lubricant (GLU-3). Other lubricants
may damage the Opener.
FCC AND IC CERTIFIED
All devices comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation.