Genie GRC-12 Service Manual

Section 3 • Scheduled Maintenance Procedures
REV B
September 2016
Part No. 227123 GRC 3 - 5
Maintenance Inspection Report
Checklist B - Rev B YNR
B-1 Batteries
B-2 Electrical wiring
B-3 Tires and wheels
B-4 Emergency stop
B-5 Key switch
B-6 Horn (if equipped)
B-7 Inverter (if equipped)
B-8 Drive brakes
B-9 Drive speed - stowed
B-10 Drive speed - raised
B-11 Drive speed - slow
B-12 Flashing beacons
B-13 Alarm (if equipped)
B-14 Hydraulic oil analysis
B-15 Breather cap
B-16 Electrical contactor
Checklist C - Rev A YNR
C-1 Breather cap - models
with optional oil
Checklist D - Rev A YNR
D-1 Tank return filter
Checklist E - Rev A YNR
E-1 Hydraulic oil
Comments
Checklist A - Rev A YNR
A-1 Inspect the manuals
and decals
A-2 Pre-operation
inspection
A-3 Function tests
Perform after 40 hours:
A-4 30 day service
Perform every 100 hours:
A-5 Grease steer yokes
Instructions
• Make copies of this report to use for
each inspection.
• Select the appropriate checklist(s) for
the type of inspection to be
performed.
Daily or 8 hours
Inspection: A
Quarterly or 250 hours
Inspection: A+B
Semi-annually or
500 hours
Inspection: A+B+C
Annually or
1000 hours
Inspection: A+B+C+D
Two year or
2000 hours
Inspection: A+B+C+D+E
• Place a check in the appropriate box
after each inspection procedure is
completed.
• Use the step-by-step procedures in
this section to learn how to perform
these inspections.
• If any inspection receives an “N”, tag
and remove the machine from
service, repair and re-inspect it. After
repair, place a check in the “R” box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company

Genie GRC-12 Specifications

General

Brand	Genie
Model	GRC-12
Category	Lifting Systems
Language	English