11
ENGLISH
Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
The symbol
indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
draws your attention to the notes on the characteristics and operation of the product.
CE DECLARATION OF CONFORMITY
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio - Bergamo- ITALY
Declares that: Control unit model SPRINT 382
conforms to the essential safety requirements of the following EEC directives:
2006/95/EC Low Voltage directive.
2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.).
Grassobbio, 15 June 2008
Managing Director
D. Gianantoni
•
•
•
INDEX
1. WARNINGS page.12
2. TECHNICAL SPECIFICATIONS page.12
3. LAYOUT AND COMPONENTS page.12
4. ELECTRIC CONNECTIONS page.12
4.1. Connection of photocells and safety devices page.13
4.2. J7 Terminal board - Power supply (fig. 2) page.14
4.3. J6 Terminal board - Motors and flashing lamp (fig. 2) page.14
4.4. J1 Terminal board - Accessories (fig. 2) page.14
4.5. Connector J2 - Rapid connection to radio-receiver module page.15
4.6. Connector J6 - Limit-switches rapid connection (fig.2) page.15
4.7. Connector J3 - Encoder rapid connection (fig.2) page.15
5. PROGRAMMING page.15
5.1. BASIC PROGRAMMING page.15
5.2. ADVANCED PROGRAMMING page.15
6. START-UP page.17
6.1. INPUTS CHECK page.17
7. AUTOMATED SYSTEM TEST page.17
To Next Page
Loading...
Need help?
General
