Zenith15/25 GNSS Series - 10 -
Installation Guide © 2017 GeoMax AG, Widnau, Switzerland
CDSB0G550: GPS, GLONASS, BeiDou tracking at 5Hz *
D2SB0GTT0: GPS & GLONASS tracking at 20Hz *
CDSB0GTT0: GPS, GLONASS, BeiDou tracking at 20Hz*
* Not applicable to Zenith15
The licence key file can be installed onto the receiver by using GeoMax Assistant. With the
receiver connected to Assistant, select Upload Key from the side menu. Select the key file
(for example L_xxx.key where xxx is the receiver serial number) and click Upload. A
confirmation message will be shown once the option has been activated.
Note:
The MicroSD card must be in the receiver when uploading the key file.
A manual entry of the license key is NOT supported. The files must be uploaded!
3.7 DISCONNECTING FROM THE PC
Once the receiver is completely configured, it can be disconnected from the PC. From the
Assistant menu bar, select File…Disconnect. The USB cable may now be removed and the
Zenith15/25 is ready for use.
4 PREPARATION OF THE HANDHELD
4.1 SETTING UP WINDOWS MOBILE
Once the battery is fully charged or while connected to AC power, press the power button
of the handheld. Follow the steps of the wizard to setup Windows Mobile. The Windows
Mobile software on the supplied Getac PS236 is only available in English language. Microsoft
restricts the installation of alternative languages with this operating system.
4.2 CONNECTING TO THE PC
To establish communication between the handheld and your PC, the Windows Mobile
Device Centre needs to be installed. For Windows XP the communication software
Microsoft ActiveSync is required. These software’s can be downloaded from Microsoft’s
website. After the software installation, connect the handheld to your PC with the USB
cable supplied with the Getac as shown below.
To Next Page
Loading...
Need help?
General
