Zenith15/25 GNSS Series - 5 -
Installation Guide © 2017 GeoMax AG, Widnau, Switzerland
3 PREPARATION OF THE GNSS RECEIVER
3.1 CONNECTING TO THE PC
Locate the Serial-to-USB cable in the yellow container. Insert a fully charged battery into
the GNSS receiver and switch it on. Connect the cable to the Lemo port of the receiver.
When connecting the cable to a USB port of the PC, the cable drivers will automatically be
installed. If the Windows Found New Hardware Wizard starts, click the Close button.
Download the USB cable driver installer CP210xVCPInstaller_x86.exe from GeoMax
Downloads. For 64-bit versions of Windows use the installer named
CP210xVCPInstaller_x64.exe. Run this file to install the USB port to Serial converter
software by following the instructions of the Windows installer wizard.
To Next Page
Loading...
Need help?
General
