Product Overview Zeta125/ Zeta125s | 43
EN
LED on the Remote Control
Keys
Status Description
LED is flashing green A key on the remote control is pressed.
LED is flashing red The batteries of the remote control are low.
Key Description
Use the left and right arrow keys for line control adjustment. The
direction of the beam travel corresponds to the arrows, when the
remote control is used from the target side.
To reset the line control adjustment, press this key for 2 seconds.
The laser beam automatically moves back to the centre position.
Press this key to put the laser into sleep mode. The display shows
SLEEP and the laser turns off. This saves power consumption.
Press the key again to turn on the laser. All settings remain the same
as when the unit was put into sleep mode.
Press this key to activate the key lock function: The display shows a
lock symbol. All keys on the remote control and on the laser are
locked. Locked keys avoid unintentional change when the laser is in
use. To deactivate the function press the lock key again.
GeoMax_Zeta125_Zeta125s_UM_v1.0.0_en.fm Page 43 Friday, November 28, 2014 9:23 AM
To Next Page
Loading...
Need help?
General
