1. Set up the Zone80 DG on a tripod.
2. Set up the tripod on a stable surface outside the working area.
3. Turn on the Zone80 DG.
4. Enter the required grade on the Zone80 DG. Refer to "3.4 Grade Entry".
5. Attach the receiver on the mast that is mounted on the machine.
6. Raise the mast until receiver is on grade with the reference line.
☞
The laser beam of the Zone80 DG acts as a constant grade reference.
7. Level the ground according to the grade reference.
8.2 Checking Grades
Application shown using the ZRP105 receiver.
To Next Page
Loading...