Troubleshooting
87
7
Chapter 7 Troubleshooting
GV-NVR System Lite V2 is designed for durability. However, should problems occur, following
the procedures here can help determine the cause.
GV-NVR System Lite V2 won’t turn on.
If your GV-NVR System Lite V2 won’t turn on or you don't hear a startup sound or any fan or
drive noise, try these steps:
1. Make sure that you press the Power button. The power LED will turn blue when the
GV-NVR System Lite V2 is turned on.
Figure 7-1
2. Make sure that the power cord is properly connected to both GV-NVR System Lite V2 and
power outlet. If you are using a power strip, make sure that the strip is powered on.
3. If the problem persists, consult your dealer.
GV-NVR System Lite V2 stops responding (aka “crashed” or froze”).
If your GV-NVR System Lite V2 is not responding to your clicking, typing, or mouse
movements, try to press the Power button on the GV-NVR System Lite V2 to turn it off. Wait
30 seconds and then press the Power button again to turn it on.
To Next Page
Loading...
