3
GV-Video Server (GV-VS04H and GV-VS14)
Refer to the figure and instructions below to load default settings for GV-VS04H and
GV-VS14.
GV-VS04H
GV-VS14
1. Press and then release the Reset button immediately.
2. Press and hold the Load Default button until all 3 LEDs (Power, Ready and Disk
Full/Fault) are on. This may take up to 30 seconds.
3. Release the Load Default button. The process of loading default values is complete,
and the GV-Video Server starts rebooting itself with all 3 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are
returned to default values.
Note: Before the Ready LED is on again, do not unplug the power cable; otherwise the
loading of default values will fail.
To Next Page
Loading...
Need help?
General
