8
Mini Fixed Rugged Dome
1. Keep the PoE cable connected to the camera.
2. Press and hold the default button.
Status LED
Default button
3. Release the default button when the status LED blinks. This shall take about 8
seconds.
4. When the status LED fades, the process of loading default settings is completed and the
camera reboots automatically.
Bullet Camera
1. Keep the power and network cables connected to the camera.
2. Loosen the camera’s cover and remove the Silica Gel Bag.
3. Press and hold the default button for 8 seconds.
Default Button
4. Release the default button. When the process of loading default settings is completed,
the camera reboots automatically.
5. Insert a new Silica Gel Bag and fasten the camera’s cover immediately.
To Next Page
Loading...
Need help?
General
