4
GV-Video Server (GV-VS11 and GV-VS12)
GV-VS11
GV-VS12
1. Unplug and plug the power cable to start.
2. Press and hold the Default button until the Ready LED blinks. This may take up to 30
seconds. The Ready LED will blink twice.
3. Release the Default button. The process of loading default values is complete, and the
GV-Video Server starts rebooting itself with the 2 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are
returned to default values.
Note: Before the Ready LED is on again, do not unplug the power cable; otherwise the
loading of default values will fail.
To Next Page
Loading...
Need help?
General
