7.1.1 Customizing GV-Video Server Settings
After the GV-Video Server is connected and assigned with a display position, you can
configure the GV-Video Server’s settings such as frame rate or resolution. Right-click the
desired GV-Video Server to see the following list of options:
Figure 7-7
Change Resolution: Note this function is only available for GV-VS11. Changes
the live view and record resolutions based on the display ratio of NTSC (3:2).
Network Time Out: When network disconnection exceeds the specified time
period, the video server status will be displayed as Connection Lost.
On Demand Display: Note this function is only available for GV-VS11. Enables
automatic adjustment of live view resolution. For details, see “On Demand Display”,
Chapter 1, GV-DVR User’s Manual.
Change Live View Codec: Note this function is only available for GV-VS11.
Changes the live view codec.
Change Record Codec: Note this function is only available for GV-VS11.
Changes the recording codec.
Live-view frame rate control (Sub stream): Note this function is only available for
GV-VS11 / 14 / 2420 / 2400 / 2401 / 2820 / 2800 / 21600. Sets the live view frame
rate of the sub stream to help reduce the CPU usage. If you have set the live view
codec to be JPEG, select the number of frames to allow in a second. If the live
view codec selected is MPEG4 or H.264, select one of the following options:
☉ Maximum Live-view Frame Rate: View the video at the maximum frame rate
possible.
144
To Next Page
Loading...
Need help?
General
