Gerber Technology AccuPlot AP-100 User Manual

Offline Operation
4-26 Diagnostic Tests
NOTE: NOTE: After rebooting, the default parameters must be reloaded using the
Parameter Entry-Load Defaults (page 4-20) and saved using Save
Parameters (page 4-19).
After loading the default parameters, enter any parameters you recorded prior
to the download procedure, in order to return the plotter to your specific
settings.
Diagnostic TestsDiagnostic Tests
Diagnostic menu commands allow you test the operation capability of plotter
components. Most of these diagnostics are used primarily by service
personnel. There are three pages of Diagnostic menu.
• Page One diagnostics test plotting capability, control panel keys and the
control panel display.
• Page Two contains tests that can be performed only by qualified service
personnel.
• Page Three tests the pen and inkjet assemblies.
Figure 4-2 shows the structure of the complete plotter Diagnostics
menu.

Gerber Technology AccuPlot AP-100 Specifications

General

Model	Accuplot AP-100
Category	Plotter
Media Types	Paper, Film
Connectivity	Parallel
Power Requirements	120 VAC

Summary

Introduction to Plotter Systems

Safety Practices and Emergency Stop

Covers essential safety procedures and the function of the emergency stop switch.

Plotter Operation: Starting and Stopping

Power On and Initialization Steps

Guide for powering on the plotter and performing initial setup.

Putting the Plotter Online

Instructions on connecting the plotter to the marking and grading system.

Stopping and Powering Down Procedures

Steps to safely stop plotter operation and shut down the unit.

Plotter Hardware Components

Offline Operation Procedures

Offline Menu Structure and Navigation

Paper Handling and Origin Setting

Servo Control and Plotter Reset

Procedures for disabling/enabling servo power and resetting the plotter.

Parameter Configuration and Settings

Parameter Overview and Modification

Timer Settings and Management

Firmware Updates and Diagnostics

Downloading and Installing Firmware

Step-by-step guide for updating the plotter's firmware.

Diagnostic Test Procedures

Specific Diagnostics (Display, Keys, Inkjet)

Details on running display, key, and inkjet diagnostics.

AccuPlot and AccuJet Maintenance

Loading Plotter Paper Procedures

Pen and Inkjet Cartridge Maintenance