Gesipa AccuBird Pro - Storage; Repairs; 2 Charger and Battery; Technical Data

22
GB
2. Charger and battery
2.1 Technical data
2.1.1 Battery charger
Input voltage: 100 V-240 V~/50-60 Hz
Output voltage: 21 VDC
Output current: 2.5 A
Weight: 0.6 kg
2.1.2 Battery
Nominal voltage: 18.0 V
Number of cells: 5
Cell/capacity: Li-Ion; 2.1 Ah
Weight: Approx. 0.42 kg
1.11 Repairs
Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in seri-
ous damage to the blind rivet setting tool. In case of doubt, always send the blind rivet set-
ting tool back to the supplier or to GESIPA
®
.
1.10 Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
2.2 Safety instructions
2.2.1 Battery charger
Caution:
The following safety rules must be observed for adequate protection against electric
VKRFNVLQMXULHVRU¿UHKD]DUGV
• The charger must be used exclusively to charge GESIPA
®
batteries.
• Check the cord, plug and charger regularly and have them repaired by Service or by an
authorised skilled specialist electrician when damaged.
• For repairs, use only genuine plugs and cords and genuine spare parts.