Gesipa AccuBird Pro - Safety Instructions

19
GB
BULB-TITE
®
Ø (mm)
Rivet material Nosepiece Part no. Jaw pusher Part no.
4 Alu/Alu 17/26 BT* 143 4985
9 143 5448
5.2 Alu/Alu 17/32 BT* 143 4986
6.3
Alu/Alu,
steel/steel
17/42 BT* 143 4988 * 143 5384
BT = BULB-TITE
®
* available as special accessories to avoid blockages.
Elongated nosepieces and other special nosepieces are available upon request.
1.5 Safety instructions
Caution:
The following safety rules must be observed for adequate protection against electric
VKRFNVLQMXULHVRU¿UHKD]DUGV
• The blind riveting tool should be used exclusively to set blind rivets!
• Do not overload the tool; work within the prescribed work capacity.
• 1HYHUXVHWKHEOLQGULYHWLQJWRROLQDKXPLGRUZHWHQYLURQPHQWRUFORVHWRLQÀDPPDEOH
substances or gases. Risk of explosion!
• Ensure that the battery is properly secured in the grip.
• Remove the battery when the blind riveting tool is not in use and for repair/servicing
operations.
• Do not use the blind riveting tool as a hammer.
• When not in use, keep the blind riveting tool in a dry, closed room and out of the reach of
children.
• When working with the tool, always wear protective goggles. Personal protection like
clothes, gloves, safety helmet, non-slip shoes, ear protection and anti-fall protection are
highly recommended.
• The air inlets for the motor should not be obstructed. Do not introduce anything into them.
• When setting the blind riveting tool down, make sure that it cannot fall.
• Use only genuine spare parts for repair.
• Repair work must be carried out by skilled workers. In case of doubt, always send the
blind riveting tool back to the manufacturer.
• Do not use the tool outside of riveting holes! The blind rivet could be ejected from the
tool! Never turn the tool towards yourself or towards another person!
• The mandrel container (n° 42) must be mounted on the blind riveting tool tool during
operation.