• If a detergent that is not part of the Getinge range is used,
ensure that the product name written on the sticker on the
inside of the detergent door matches the name of the product
on the container. If detergent is being replaced for the
detergent wand labeled Dos 1, the product name on the new
container should correspond with the product name on the
Dos 1 detergent wand.
1. Marking tape
2. Sticker with product name for the appropriate dosing
pump, found on inside of detergent door
• If both tag and marking tape are missing from the gray lead
between the detergent wand and the detergent pump, please
contact your Getinge service representative to verify that the
correct chemical agent (detergent) is being installed.
5. Place the container in the detergent cabinet and close the
door.
6 MAINTENANCE
User Manual Getinge 46-series 31 (56)
<Doc_USR><Doc_6002267102><Rev.B><Lang_en>
To Next Page
Loading...
