6.2.2 Fill up with detergent
WARNING!
If the washer is used with external loading
equipment (for example AGS), watch out for
moving shuttles in the marked area.
Follow these steps to replace an empty detergent container:
1. Open the door to the detergent cabinet and lift out the
container to be replaced.
Note!
Handle the suction lances with care. DO NOT hit the
suction lance against the container to remove excess
detergent.
2. Remove the detergent wand from the container. Have a cloth
ready for wiping up excess detergent.
3. Check whether there is any crystallized detergent that could
affect the functioning of the detergent wand or level sensor.
Clean as required.
4. Insert the detergent wand in a new detergent container. Make
sure that the new container contains the correct detergent as
follows:
• If detergent from the Getinge range is used, the tag on the
gray lead between the detergent wand and the detergent
pump should be labeled with the product name on the
detergent container.
1. Tag with product name
6 MAINTENANCE
30 (56) User Manual Getinge 46-series
<Doc_USR><Doc_6002267102><Rev.B><Lang_en>
To Next Page
Loading...
