Getinge 46 Series - Maintenance of Parts Inside the Chamber

6.2.3 Maintenance of parts inside the chamber
6.2.3.1 Clean the spray arm
6.2.3.1.1 Positioning
000826
6.2.3.1.2 Remove and clean the spray arm
003935
2
1
3
1. Spray arm
2. Metal clip
3. End pieces
Remove and clean the spray arm as follows:
1. Unscrew the center nut and remove the spray arm.
2. Rinse off the spray arm.
3. Push the metal clips away from the edges of the plastic end
pieces and remove them.
4. Using a bottle brush, clean the inside of the spray arm.
6 MAINTENANCE
32 (56) User Manual Getinge 46-series
<Doc_USR><Doc_6002267102><Rev.B><Lang_en>