35
Starting via operator panel OP20
After completion of the process
The control panel displays progress of the process.
• Make sure that process media are available.
• Close the door by pressing the button.
Process adaptation must be done beforethe start button is
pressed. If the lamp does not light up, starting is being
prevented by a condition; see also the Operation and
Control unit chapters.
When the lamp is lit, press the button.
With a normal program
The process starts.
With a password-protected program
This happens instead:
• The display shows the menu for entering the password.
• Press the button.
• Key in the password with the arrow keys and press the
button again.
The process starts.
Beware of hot surfaces inside the sterilizer chamber when
door is open!
To Next Page
Loading...
