Getinge HS 6613 AR-2 - The Operators Menu Tree; Description of Operator Menu Tree; Main Menu 1; Select Cycle

46
The operator’s menu tree
Description of operator menu tree
Main menu 1
In the standby position (with no program started) the top line shows the
chosen program and its program number. The bottom line shows the
values of two preselected parameters. These are usually treatment tem-
perature and time.
When you start a program, the bottom line shows the name of a
preselected variable and its value. Usually the remaining time is
displayed.
If you press ENTER once, a screen appears on which you can choose
a program and change parameters.
Select cycle
Use the up- and down-arrow keys to highlight the desired program and
choose it by pressing ENTER. Note that a password is required in order
to start certain programs.
Change parameter
A list of the parameters in the chosen program is displayed here. To
access the list you must enter the correct password. Parameters pre-
ceded by an “A” (= adjustable) can be modified. Parameters preceded
by an “I” (= information) cannot be changed.
Main menu 1
Program name
Select cycle
Main menu 2
Main menu 3
Main menu 4
Parameter
List of variables
Setup
Print last cycle
Subphase Phase
Parameter 1 & 2
Change parameter (password)
Node id Machine
Select PACS
System menu (password)
About