Getinge ProSeal Classic - Page 18

SERVICE MANUAL ProSeal Classic/Plus/Premium
18
18
Temperature
difference error
Large temperature
difference between
lower and upper
heater element
 Cable heating element (power) disconnected /
broken
 One of the 2 heating elements defect (check
resistance, should be almost equal)
 Cable temperature sensor disconnected /
broken
 Temperature sensor on heating element defect
 Control PCB defect
19
Heating error
Heating elements
are on but the
temperature doesn't
rise (fast enough).
 Cable heating element (power) disconnected /
broken
 Thermostat upper heating element activated
 Thermostat lower heating element activated
 Heating element(s) defect (check resistance)
 Cable temperature sensor disconnected /
broken
 Temperature sensor on heating element defect
 Control PCB defect
To reset thermostat:
Wait until heating elements are cooled down and
press button on thermostat to reset, use low force.
If thermostat was activated a click can be felt when
pressing the reset button
20
Temp1K8Calib
error
Temperature self-
test of the control
PCB failed.
 Control PCB defect
21
Temp1K2Calib
error
Temperature self-
test of the control
PCB failed.
 Control PCB defect
22
PressFullCalib
error
Pressure self-test of
the control PCB
failed.
 Control PCB defect
23
PressNullCalib
error
Pressure self-test of
the control PCB
failed.
 Control PCB defect
24
Pressure sensor 1
error
No communication
with pressure sensor
1
 Cable pressure sensor disconnected / broken
 Pressure sensor defect
 Control PCB defect
25
Pressure sensor 2
error
No communication
with pressure sensor
2
 Cable pressure sensor disconnected / broken
 Pressure sensor defect
 Control PCB defect
26
SPI flash error
Error while
communicating with
flash memory
 Firmware update
 Control PCB defect
27
Mains detection
error
Error while
measuring mains
frequency and
voltage
 Mains voltage or frequency out of range for
sealer specification
 Control PCB defect
28
Temperature
overheat error
Temperature of one
or two temperature
sensors above
210°C
 Cable temperature sensor disconnected /
broken
 Temperature sensor on heating element defect
 Control PCB defect