1. Undo screws (A) and remove the cover.
2. Pull out the handle (B) and take out the cassette.
3. Take a suitable plastic wash basin in which the filter cassette
can be completely immersed.
4. Fill up with approx 60 °C hot water and add about 1% alkaline
detergent.
5. Stir the solution and carefully immerse the filter cassette.
6. Take out the filter after 15–30 minutes and rinse it on all sides
with clean water under a running water-tap.
7. Place the filter on water-absorbent paper or lint for 24 hours.
8. Do not use compressed air for cleaning or drying.
9. Check that the filter cassette has dried completely.
10. Put the cassette back into place after cleaning it. N.B. Make
sure the cassette is not turned upside down. The contacts (C)
at the back of the filter should face downwards.
Do not use sharp implements when dismantling.
7.4 Overheating cut-out
WARNING!
Only to be carried out by authorized staff.
WARNING!
Before starting work, make sure that the machine
is disconnected from the electric power supply.
If the heating fails to work, or the fan fails to start, the over-heating
cut-out may have tripped. Remove front panel A. Reset the cut-out
by pressing red button B.
7 ERROR CODE 1
USER MANUAL GETINGE DRYING CABINET S-363 17 (24)
<Doc_6001300802><Rev.C><Lang_en>
To Next Page
Loading...
Need help?
General
