3.1 DRYING CABINET
Made of stainless steel, SIS 2333, with a base and four adjustable
feet. Insulated with 20 mm mineral wool sheets.
The cabinet operates with recirculated hot air, approximately 80%
recirculation and 20% additional electrostatically-filtered air.
Automatic electronic controls with display of the drying time. The
drying time can be adjusted from 0-95 minutes. The time is
counted down in steps of 1 minute during the process so that the
display shows how much drying time is left. When the drying time
is complete, the fan runs for an additional 2 minutes with the heater
switched off so that the overheating cut-out does not trip.
There are two heater settings: 70° C for plastics and 90° C for
rubber hoses and instruments.
The display alternates between
and the drying time when the
filter needs cleaning.
3.1.1 Construction
The cabinet is available as a single configuration or a through-put
cabinet. The doors are fitted with a cremone bolt, either right-
handed or left-handed.
3.1.2
Capacity
36 hoses or 9 DIN baskets or 9 shelves or SPRI I racks or 18
hoses and 8 shelves with SPRI II racks.
3 TECHNICAL DATA
USER MANUAL GETINGE DRYING CABINET S-363 9 (24)
<Doc_6001300802><Rev.C><Lang_en>
To Next Page
Loading...
