EasyManuals Logo

GEZE GC 342 User Manual

GEZE GC 342
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
SafetyGC 342 safety sensor
à Only original GEZE parts may be used for repair and maintenance work.
à Observe the latest versions of directives, standards and country-specic
regulations, in particular:
à ASR A1.7 “Doors and gates”
à DIN 18650 “Building hardware – Powered pedestrian doors”
à DIN EN 16005 “Power operated pedestrian doorsets – Safety in use –
Requirements and test methods”
à Accident-prevention regulations, especially BGV A1 “General regula-
tions” and BGV A2 “Electrical installations and equipment.
à The risk assessment and installation of the sensor and the door system
in compliance with national and international regulations and door safety
standards are the responsibility of the door manufacturer.
à Any uses of the device other than those described in this manual do not
correspond to the approved purpose and cannot be guaranteed by the
manufacturer.
2.3 Safety-conscious working
à Secure workplace against unauthorised entry.
à Watch the swivelling range of long system parts.
à Never carry out high-risk work alone.
à Secure the cover/drive panels against falling.
à Only use the cables prescribed in the cable plan provided. Cables must
be shielded in compliance with the wiring diagram.
à Secure loose, internal drive cables with cable ties.
à Before working on the electrical system:
à Disconnect the drive from the 230-V mains and check to ensure that
it is not supplied with power.
à Disconnect the control unit from the 24-V rechargeable battery.
à When an Uninterruptible Power Supply (UPS) is used, the system will still
be under voltage even when disconnected from the mains.
à Always use insulated wire-end ferrules for wire cores.
à Make sure of sucient lighting.
à Danger of injury with opened drive. Hair, clothing, cables, etc. can be drawn
in by rotating parts!
à Danger of injury caused by unsecured crushing, impact, drawing-in
or shearing spots!
à Danger of injury due to glass breakage!
à Danger of injury due to sharp edges in the drive!
à Danger of injury during installation through freely moving parts!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GEZE GC 342 and is the answer not in the manual?

GEZE GC 342 Specifications

General IconGeneral
BrandGEZE
ModelGC 342
CategoryAccessories
LanguageEnglish

Related product manuals