5. Now, locate the device in the network using the Lynx Locator utility
6. Enter the IP address of the device displayed in the Lynx Locator utility in the address
bar of the web browser.
7. Now change the IP address to static and configuration settings of the device if
required.
8. Revert back IP address settings of PC, and locate device in Lynx Locator utility with
new assigned IP address.
9. If the IP address assigned to the device and PC are in different networks, device will
not be located in Lynx Locator Utility, press Reset (RST) to restore Factory Default
Settings as shown in section 2.4.2.
To Next Page
Loading...