Driver 2 Settings
Driver1 is used to edit the settings of Modbus TCP for both Server / Client.
Click on the Driver2 Settings tab to view or edit the Serial Port settings for Port 2
If port is updated, it should be other than the standard port number.
TCP timeout:
It is the time after which the TCP connection will break if it is in idle state. If this time is not
provided then by default the TCP connection will break in 2 seconds.
Response Timeout:
Timeout is applicable only for Master/Client driver. It is the time for which the device will
wait for the response from external Slave device.
Delay between Polls:
Delay between polls is applicable only for Master/Client driver. This is the delay between 2
consecutive requests.
Retry Count:
Retry count is applicable only for Master/Client driver. It is the number of times, the
To Next Page
Loading...