Giga-tronics 2508A - Page 124

132 pages

Save Page as PDF

To Next Page

To Previous Page

2500A Series Microwave Synthesizer: Accessories & Options

124 2500A Series Operation Manual, 34172 Revision C, March 2008

Table A-2: Option 55 Command Sets

Option Command St

55A HP 8370

55B HP 8340

55C HP 8673

55D HP 8663

55E Systron Donner 1720

55F Wavetek 90X

55G HP 8350

55H HP 8360

Main Page

Default Chapter3
- Declaration of Conformity3
- Table of Contents9
Chapter 1: 2500A Introduction13
Overview13
- 2500A Frequency Ranges13
- 2500A Options14
- Items Furnished14
- Items Required14
General Information15
- Receiving Inspection15
- Cooling15
- Cleaning15
- Power15
- Line Fuse17
  - Line Fuse Replacement17
- Calibration Cycle18
- Reshipment Preparation18
Inputs and Outputs18
- Front Panel Connector (RF Output)19
- Rear Panel Interface and I/O Connectors19
Chapter 2: Front23
Introduction23
Front Panel at a Glance23
- Front Panel Description24
2500A Menus26
- Menu System Overview27
  - Menu Buttons27
- CW Menu Descriptions28
  - Cable Cal Menu30
- RAMP Menu Descriptions30
- SYSTEM Menu Descriptions36
- AM Menu Descriptions40
- FM Menu Descriptions43
- PM Menu Descriptions46
- Language Menu Descriptions52
Front Panel Operating Tasks55
- Power-Up55
  - Normal Power-Up55
  - Errors During Power-Up57
- Basic Operating Tasks57
  - Resetting the System/Sanitization Procedure57
  - Entering and Modifying Parameters57
- Signal Generation59
- Required Equipment63
- Remote Setup68
  - Setting the GPIB Address68
  - Selecting the Remote Language68
Chapter 3 : Remote Operation69
Introduction69
- What Is Automation Xpress69
- Interface Bus (GPIB) or RS69
- Computer Interfaces70
SCPI Command Set71
- SCPI Command Format71
- SCPI Command Subsystems72
IEEE 488.2 Common Commands81
2500A Specific Commands82
Status Register System83
- Status Byte (STB) and Service Request Enable (SRE)84
  - Registers84
- Standard Event Status (ESR) and Standard Event Status84
  - Enable (ESE) Registers84
- Questionable Status Condition and Enable Registers85
- List Mode Operation86
  - Example: List Mode86
Specifications & Performance Verification89
Models89
Specifications89
- Frequency89
  - Frequency Bands90
- Output Power91
- Spectral Purity92
- List Mode93
- Amplitude Modulation94
- Frequency Modulation94
- Pulse Modulation94
- External ALC95
- Internal Modulation Generator96
- 4.2.10 General Specifications97
Performance Verification98
- Recommended Equipment98
- Performance Tests: All 2500A Series99
- Performance Tests: 2500A Series104
- 2500A Series Test Datasheets116
Accessories & Options123
Introduction123
List of Accessories and Options123
Appendix A: a Ccessories & Options125
Appendix B: Error Messages125
Start-Up Error Messages125
NVRAM Messages126
- NVRAM Reset Due to a Firmware Upgrade127
- NVRAM Reset Due to a Battery Failure127
- NVRAM Reset Due to a Checksum Failure127
Remote Error Messages128

Giga-tronics 2508A - Page 124

Table of Contents

Related product manuals