Gigabyte 7002 Series - BIOS POST Beep Code (AMI Standard); PEI Beep Codes; DXE Beep Codes

BIOS Setup - 136 -
5-12 BIOS POST Beep code (AMI standard)
5-12-1 PEI Beep Codes
# of Beeps Description
1 Memory not Installed.
1 Memory was installed twice (InstallPeiMemory routine in PEI Core called
twice)
2 Recovery started
3
DXEIPL was not found
3
DXE Core Firmware Volume was not found
4
Recovery failed
4
S3 Resume failed
7 Reset PPI is not available
5-12-2 DXE Beep Codes
# of Beeps Description
1 Invalid password
4 Some of the Architectural Protocols are not available
5 No Console Output Devices are found
5 No Console Input Devices are found
6 Flash update is failed
7 Reset protocol is not available
8 Platform PCI resource requirements cannot be met