Gigabyte MJ11-EC0 - Page 59

- 59 - BIOS Setup
Parameter Description
USBCongurationOptions
(continued)
– XHCI2 enable (MCM1/Die0)
»
Options available: Auto, Enabled, Disabled. Default setting is
Auto.
– XHCI3 enable (MCM1/Die1)
»
Options available: Auto, Enabled, Disabled. Default setting is
Auto.
SD (Secure Digital) Options
Press[Enter]forcongurationofadvanceditems.

SDCongurationMode
– Selects the SD mode.
– Options available: Disabled, Ver2.0, SdDump, Auto (Version 2.0 +
Low Speed). Default setting is Auto.
AC Power Loss Options
Press[Enter]forcongurationofadvanceditems.

AC Loss Control
– Selects the AC Loss Control Method.
– Options available: Always Off, Always On, Reserved, Previous.
Default setting is Always On.
I2CCongurationOptions
Press[Enter]forcongurationofadvanceditems.

I2C 0/1/2/3/4/5 Enable
– Enable/Disable I2C 0/1/2/3/4/5.
– Options available: Auto, Enabled, Disabled. Default setting is Auto.
UartCongurationOptions
Press[Enter]forcongurationofadvanceditems.

Uart 0 Enable
– Uart 0 has no HW FC if Uart 2 is enabled.
– Options available: Auto, Enabled, Disabled. Default setting is
Enabled.

Uart 0 Legacy Options
– Options available: Disabled, 0x2E8, 0x2F8, 0x3E8, 0x3F8. Default
setting is Disabled.

Uart 1 Enable
– Uart 1 has no HW FC if Uart 3 is enabled.
– Options available: Auto, Enabled, Disabled. Default setting is
Enabled.

Uart 1 Legacy Options
– Options available: Disabled, 0x2E8, 0x2F8, 0x3E8, 0x3F8. Default
setting is Disabled.

Uart 2 Enable (no HW FC)
– Options available: Auto, Enabled, Disabled. Default setting is Auto.

Uart 3 Enable (no HW FC)
– Options available: Auto, Enabled, Disabled. Default setting is Auto.
ESPICongurationOptions
Press[Enter]forcongurationofadvanceditems.

ESPI Enable
– Options available: Auto, Enabled, Disabled. Default setting is Auto.