Gigabyte MNJ190I-FH - SPK_OUT (Audio Amplifier Connector); F_PANEL (Front Panel Header)

Hardware Installation
- 22 -
25) SPK_OUT(AudioAmplierConnector)
PinNo. Denition
1 OUT_L+
2 OUT_L-
3 OUT_R-
4 OUT_R+
26) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this
header according to the pin assignments below. Note the positive and negative pins before connecting
the cables.
PinNo. SignalName Denition
1 MPD- Hard Disk LED Signal cathode(-)
2 MPD+ Hard Disk LED Signal anode (+)
3 PWR_F_BTN# Power Button
4 GND Ground
5 -ACT_LED LAN Activity LED cathode(-)
6 +ACT_LED LAN Activity LED anode (+)
7 HD- Hard Disk LED Signal cathode(-)
8 HD+ Hard Disk LED Signal anode (+)
9 -SYS_RST Reset button
10 5VDUAL 5V
2 1
910
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the pin assignments are matched
correctly.
4 1