Gigabyte MZ73-LM1 - Page 70

BIOS Setup
- 70 -
Parameter
Description
iSCSI General Parameters
(continued)

Use TCP Timestamp
– Enable/Disable the TCP timestamp.
– Options available: Disabled, Enabled. Default setting is Disabled.

Target as First HDD
– Enable/Disabletargetappearsasrstharddiskdrive(HDD)inthe
system.
– Options available: Disabled, Enabled. Default setting is Disabled.

LUN Busy Retry Count
– Conguresthenumberofretriesin2secondintervalswhenLUNis
busy (0-60).
– Default setting is 0.

IP Version
– Displays the IP version supported. Modifying this parameter will reset
allIP-relatedelds.
– Options available: IPv4, IPv6. Disabled. Default setting is IPv4.
iSCSI Initiator Parameters
Press[Enter]tocongureadvanceditems.

IP Address
– CongurestheinitiatorIPaddress.

Subnet Mask
– CongurestheIPsubnetmask.

Default Gateway
– ConguresthedefaultgatewayIPaddress.

Primary DNS
– CongurestheprimaryDNSIPaddress.

Secondary DNS
– ConguresthesecondaryDNSIPaddress.

iSCSI Name
– CongurestheiSCSIname.

CHAP ID
– CongurestheChallenge-HandshakeAuthenticationProtocol
(CHAP) ID (up to 128 characters in length).

CHAP Secret
– ConguretheChallenge-HandshakeAuthenticationProtocol
(CHAP) Secret (12 to 16 characters in length).
iSCSI First/Second Target
Parameters
Press[Enter]tocongureadvanceditems.

Connect
– Enable/Disable the target establishment.
– Options available: Disabled, Enabled. Default setting is Disabled.

IP Address
– CongurestheTargetIPaddress.

TCP Port
– CongurestheTargetTCPportnumber(1-65535).