42
Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0
ECO DECT
Gigaset E370A / LUG UK-IE en / A31008-M2841-L101-1-7619 / applications_1_A.fm / 9/14/17
Deactivate baby monitor / cancel alarm
Deactivate the baby monitor remotely
¤ Accept alarm call Press keys
The baby monitor is deactivated and the handset is in idle status. The baby monitor settings
on the handset (e
.g. no ringtone) will remain activated until you press the display key OFF.
Reactivate baby monitor with the same number: . . . A
ctivation to switch back on ( p. 41)
Save
ECO DECT
The device range is set to maximum as default. This guarantees the best connection between
the handset and the base station. In idle status, the handset will not function (as it is not
transmitting). Only the base station will maintain contact with the handset via a low wireless
signal. During a call, the transmission power automatically adapts to the distance between the
base station and handset. The smaller the distance to the base, the lower the radiation.
To reduce the radiation further:
Reducing radiation by up to 80%
Deactivate the baby monitor: ¤ In idle status press the display key OFF
Cancel the alarm:
¤ Press the End call key during an alarm
The alarm is forwarded to an external destination number.
The receiving phone supports tone dialling.
¤ . . . use to select Settings OK ECO DECT OK Maximum
Range Chang
e ( = off)
The range is also reduced with this setting.
It is not possible to use a repeater to increase the range.
To Next Page
Loading...
